MIXER
Audio is mixed with the mixer before being fed to the input of the
filter.
The levels can be set way beyond clean allowing the signals to
overdrive and distort giving the synth a wonderful hard or angry
sound. This is great when filtered and/or used for bass lines.
There are points where you can set it all to almost distort - be
just on the borderline. It may be here that you get some subtle
crackling. If this does occur, simply tweak the levels a little lower
to get a clean signal, or a little high to overdrive more.
NOISE / EXTERNAL TOGGLE SWITCH
The switch selects either white noise or the signal (if any)
patched into the EXT socket.
SUB VCO1
This is the sub-oscillator taken from VCO1. It’s one octave down
and typically used to beef up sounds, particularly bass!
VCO 1 / 2
WAVEFORM
TOGGLE SWITCH
The switch selects either Sawtooth or Square wave.
VCO 2 WAVEFORM TOGGLE SWITCH
The switch selects either Sawtooth or Square wave. VCO2’s square wave can play a
rhythm, as programmed on the step sequencer with the PROG button and when using
the switch below.
RHY TOGGLE SWITCH
To do this set the waveform switch of VCO2 to Square, and the RHY (rhythm) switch
down (on). More details on this and its uses are in the sequencer section.
Analogue Solutions 2021 02
