UG-260
Evaluation Board User Guide
Rev. 0 | Page 4 of 20
5.
To start the installation, click
Next
. The installer completes
installation of the software evaluation GUI and all required
National Instruments drivers and run-time engines. After
the installation is complete, the box shown in Figure 5 is
displayed.
0
97
51
-0
14
Figure 5. Installation Complete
6.
Click
Finish
to complete the installation. Reboot your
computer if prompted.
ISEB HARDWARE SETUP
Before connecting the ISEB hardware to the PC via the included
USB cable, drivers must be installed so that the PC properly
recognizes the ISEB main board. The USB drivers for the ISEB
are available in the /
ISEB_USB
/ folder on the packaged CD.
Installing the USB Drivers for the ISEB
To install the USB drivers, follow these steps:
1.
Open the
/ISEB_USB/
folder and locate the appropriate
folder for your operating system. If running Windows 7,
follow the instructions at
/ISEB_USB/ADI_ISEB_Win7/
.
For other versions of Windows (2000, XP, or Vista),
execute the
ADI_ISEB_USB_Drivers.exe
file located in
/
ISEB_USB/ADI_ISEB_XP_Vista_2000/
and continue to
Step 2.
2.
Follow the on-screen instructions to install the drivers.
3.
Click
Continue Anyway
when prompted that the drivers
are not tested.
After the preceding steps are complete, you can connect the
ISEB main board to the computer via the included USB cable. If
the previously installed drivers are not automatically associated
with the device, you may need to select the drivers manually, as
follows:
1.
Connect the USB A to Mini-B cable to the PC and then to
the ISEB. The satellite board does not need to be connected
for this step. New hardware is detected upon completion of
this step.
2.
If prompted to install drivers again, click
Install from a list or
specific location (Advanced) (
see Figure 6); then click
Next
.
09
75
1-
00
2
Figure 6. Found New Hardware Prompt
3.
Select
Don’t search. I will choose the driver to install
(see
Figure 7), and click
Next
.
09
75
1-
0
03
Figure 7. Selection of the Driver to Install
4.
Select
ADI Inertial Sensor Evaluation System
from the
model list (see Figure 8), and click
Next
to complete the
process.
09
75
1-
0
04
Figure 8. Selection of the ADI Inertial Sensor Evaluation System Drivers
Downloaded from
Downloaded from
Downloaded from
Downloaded from
