EVAL-ADXRS290Z-M User Guide
UG-783
Rev. 0 | Page 3 of 14
GETTING STARTED
This section provides quick start procedures for using the
EVAL-ADXRS290Z-M
board and describes both the default
and optional settings. Follow these steps to set up and run the
ADXRS290
evaluation system:
1.
Install the USB drivers for the ISEB.
2.
Connect the ISEB hardware to the PC.
3.
Install the latest ISEB firmware revision onto the ISEB
hardware from the
FTP
site. This step is unnecessary for
most cases because the default firmware matches the
default GUI. If you have ever reprogrammed the
microcontroller unit (MCU) for other applications, or the
firmware or GUI is updated by Analog Devices, you need
to download the corresponding firmware for evaluating the
ADXRS290
. The firmware and GUI installer on the
FTP
site must always match each other. When installing the
firmware, ensure that the satellite board is disconnected
from the main board.
4.
Install the run time engine and the
ADXRS290
evaluation
GUI.
5.
Configure the ISEB hardware.
6.
Launch the
ADXRS290
software evaluation GUI and test
the devices.
SOFTWARE INSTALLATION PROCEDURES
Install USB Drivers
The USB driver supports Windows 7 and its previous operating
systems. To install the USB drivers, follow these steps:
1.
Execute the
ADI_ISEB_USB_Drivers.exe
file located in
ftp://ftp.analog.com/pub/iMEMS_Sensor_Eval/ISEB_USB_
Driver/.
2.
Follow the on-screen instructions to install the drivers.
3.
Click
Continue Anyway
when prompted that the drivers
are not tested.
After the previous steps are complete, connect the ISEB to the
computer via the included USB A to mini-B cable. If the previously
installed drivers are not automatically associated with the device,
you may need to select the drivers manually, as follows:
1.
Connect the USB A to mini-B cable to the PC and then to
the ISEB. The satellite board does not need to be connected
for this step. New hardware is detected upon completion of
this step.
2.
If prompted to install drivers again, click
Install from a list
or specific location (Advanced)
, and then click
Next
(see
Figure 2).
1
283
6-
0
02
Figure 2.
Found New Hardware
Prompt
3.
Select
Don’t search. I will choose the driver to install
(see
Figure 3), and click
Next
.
12
83
6-
0
0
3
Figure 3. Selection of the Driver to Install
4.
Select
ADI Inertial Sensor Evaluation System
from the
model list (see Figure 4), and click
Next
to complete the
process.
12
83
6-
0
04
Figure 4. Selection of the ADI Inertial Sensor Evaluation System Drivers
