Distributor of Analog Devices Inc.: Excellent Integrated System Limited
Datasheet of ADZS-BFSHUSB-EZEXT - BOARD DAUGHTER EZ EXTENDER
Contact us: [email protected] Website: www.integrated-circuit.com
Blackfin/SHARC USB EZ-Extender Setup
1-2
Blackfin/SHARC USB EZ-Extender Manual
Blackfin/SHARC USB EZ-Extender Setup
It is very important to set up all components of the system containing the
Blackfin/SHARC USB EZ-Extender, then apply power to the system. The
following procedure is recommended for correct setup.
Power your system after these steps are completed:
1. Read the applicable design interface section in this chapter—the
text provides an overview of the interface capabilities.
2. Read
“System Architecture” on page 2-2
to understand physical
connections of the extender board. For detailed information, refer
to
“Blackfin/SHARC USB EZ-Extender Schematic” on page B-1
.
3. Set the jumpers on the Blackfin/SHARC USB EZ-Extender board.
Use the block diagram in
Figure 2-1 on page 2-2
in conjunction
with
“Jumper Settings” on page 2-3
.
4. Set the switches and jumpers on the EZ-Board. If not already,
familiarize yourself with the EZ-Board documentation and sche-
matic drawings (see
“Product Information”
).
Compare the expansion interface signals of the Blackfin/SHARC
USB EZ-Extender board with the EZ-Board signals to ensure there
is no contention. For example, it may be necessary to disable other
devices connected to the expansion interface of the processor and
disable peripherals on the EZ-Board.
5. Install the Blackfin/SHARC USB EZ-Extender on the EZ-Board
via the high speed expansion interface.
17 / 29
17 / 29
