Analog Devices ADSP2192-12 EZ-KIT LITE, Руководство пользователя

Страница: 13 / 50

ADSP2192-12 EZ-KIT Lite Evaluation System Manual
2-2
2.4 Installation Procedures
The following procedures ensure reliable operation of the ADSP2192-12 evaluation board. It is
important that you follow these instructions in the order presented to ensure correct operation of
your software and hardware.
2.4.1 Installing the EZ-KIT Lite Hardware
The ADSP2192-12 EZ-KIT Lite board is designed to run inside your personal computer. You will
have to access the inside of your computer to install the board. Use the following steps to configure
the EZ-KIT Lite:
1. Remove the EZ-KIT Lite board from the package—be careful when handling the board to avoid
the discharge of static electricity, which may damage some components.
2. Make sure the switch (SW4) is in the correct position for PCI operation.
SW4
PCI
NOTE: Do not change the position of this switch while power is applied to the board. This may
damage components on the board.
3. Make sure jumper JP1 is installed correctly. For PCI, JP1 should have jumpers installed on pins
1 & 2 and pins 3 & 4. Refer to Hardware Section (Section 4.5) of this manual if more
information of jumper settings is required.
4. To configure your board to take advantage of the audio capabilities, use the following
procedure:
a) Place the appropriate jumpers on JP4. The default is Line In, and the jumpers should
be placed on pins 3 & 5, and pins 4 & 6, respectively.
b) If Mic In operation is required, then Jumpers on JP4 should be placed on pins 1 & 3,
and pins 2 & 4, respectively.
If more information is required, please see the Hardware Section (Section 4.5.4) of this
manual.
5. Turn off power to your PC.
6. Find an empty PCI slot in your computer and place the ADSP2192-12 EZ KIT Lite in the empty
PCI slot.
7. Screw in the bracket so that the board has a strong and direct contact to the chassis ground of
the computer and the PCI contacts seat securely.
8. If audio capabilities are being used, connect a 1/8” cable from a self-powered speaker into the
1/8” audio jack labeled “OUT”on the bracket of the EZ-KIT Lite.
9. Connect a microphone or the appropriate Line In cable into the 1/8” audio jack, labeled “IN”,
on the bracket of the EZ-KIT Lite.
www.BDTIC.com/ADI