Chapter 3: Directions for use
Before using the appliance for the first time, clean its parts in contact with food ingredients thoroughly
(please refer to “Chapter 4: Maintenance”).
Button operation instructions:
“ON” button: Normal use
“0” button: Close and stop
“R” button: It is used when pulp discharge is blocked or the
motor is locked
I. Use of the appliance
Please install and use the appliance following the steps below.
1
Connect the juicing body and the main body:
1. Have the triangular aligning sign
“
▼
”
on the juicing body align
with the aligning
“
unlocking triangular sign
”
on the main body
and then put the juicing body into the main body (the three clips
on the juicing body will realize alignment).
2. Then turn the juicing body anticlockwise. When there is a click, it
suggests that the connection is finished.
2
Have the hexagonal shaft of the spiral pusher align with the hole on
the main body and push it horizontally until it reaches the bottom
(when alignment fails, just turn the spiral pusher slightly).
3
Fit the larger-hole end of the juicer strainer into the tail of the spiral
pusher and push it while the three clips of the juicer strainer align
with the three clamping slots in the juicing body. (The juice strainer is
used with the juicing button in the rear only. This function is used for
juicing.)
4
Align the triangle alignment mark on the juice extractor with the
unlock triangle mark on the juice extractor, and then put the
juice into the juice extractor.
5