Basic Steps to Install
1. Plugs the mains adapter to the wall mains supply.
2. Place the 2 rechargeable NiMH AAA batteries (included), observing
their polarities, into the battery compartment on the handset.
3. Slide the battery door firmly into place.
4. Place the handset on the charger and let the batteries charge for a
full 14 hours before using for first time installation.
5. Register the handset to the base unit (Refer to Registration Section
for details).
CAUTION
Use only the mains adapter supplied with this telephone.
Incorrect adapter polarity or voltage can seriously damage the
unit.
Input: 230 VAC 50 Hz
Output: 9 VDC 150 mA
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE. Never use non-rechargeable batteries; use
recommended type supplied with this telephone. NiMH batteries
must be disposed of in accordance with applicable waste disposal
regulations.
Battery Level Indication
The Battery icon is always displayed when the
handset is on. When charging, the battery icon will be
scrolling to indicate that the batteries are being
charged. When fully charged, four bars are displayed.
The scrolling will stop.
When an empty battery icon is displayed, place the
handset on the base cradle to recharge the batteries.
If low battery level happens during off-hook, a series
of short beeps will be heard from the speaker of the
handset.
Charging the Handset
When the handset is placed on the charger to charge the handset
batteries, a charging tone, if set to On, will be emitted from the
handset’s speaker. During charging, the charge LED on the charger will
be steadily lit.
Get into the habit of putting the handset on the charger to charge when
it is not in use to ensure the handset is always fully charged.
5
6