AMX VTX, Инструкция по эксплуатации

Страница: 11 / 58

VTX Video Teleconferencing System - Preliminary Pre-Installation 7
Pre-Installation
Overview
The section describes the configuration required prior to installing the VTX system.
You will need to:
•
Obtain and record the specific ISDN information
•
Properly position the TiltCam for use
•
Prepare the AXlink wires, if you are manufacturing the cables
•
Wire the system for AXlink and power
ISDN Information
When you call and request service, obtain the information from the telephone
company Central Office (CO) about the Integrated System Digital Network (ISDN).
Record the information on the form in Appendix A: ISDN Form. Obtain and record all
the information listed in the form. It will assist in identifying the ISDN line, should
you ever need to contact the CO about the service.
To record all the ISDN information:
1.
Record the work order information, the cost information, and the ISDN
information.
2.
Enter the ISDN line information. For each ISDN Billing Rate Identification (BRI)
line, there will be two numbers, the telephone number and the Service Profile
Identification (SPID).
3.
Enter the service provider’s information.
4.
Enter the Circuit IDs for the D channel and the B channel. The representative
will not know this ID; they must obtain it from the engineering group. Have
them get you that information.
5.
Enter the service provider’s Preferred Interexchange Carrier (PIC) code.
6.
Enter the their repair telephone number.
Note
We recommend that you have
the service provider perform all
the inside wiring.