AMX TXC4 Series, Инструкция по эксплуатации

Страница: 9 / 24

TXC Wireless Transmitters IR, RF, Radio Code, and Frequency Settings 5
IR, RF, Radio Code, and IR
Frequency Settings
Overview
The TXC series transmitters transmit IR or RF signals, depending on how you set
positions 1, 2, and 3 on the 10-position DIP switch (Figure 4) located under the
battery cover. You must set the DIP switch position 3 to ON for RF mode.
IR, RF, and IR Frequency Settings
Figure 4 shows the DIP switch settings for IR and RF modes.
1 2 3 4 5 6 7 8
ON
38 kHz IR mode
1 2 3 4 5 6 7 8
ON
455 kHz IR mode
1 2 3 4 5 6 7 8
ON
RF mode
Radio Code
Each pushbutton on your transmitter represents an AXCESS channel number. All of
the pushbuttons on a transmitter represents a group of channel numbers. This
grouping is known as a radio code. After the radio code is set on the transmitter,
each button you press sends a specific channel number to the control system. For
example, if your TXC16+ transmitter is set to radio code 4 and you press button 1,
channel number 64 is sent to the control system (Figure 7).
1 2 3 4 5 6 7 8
ON
Figure 4
DIP switch settings for IR and
RF modes
Note
Do not set both DIP switch
positions 1 and 2 to the ON
position, or the batteries may
prematurely lose power.
Figure 5
TXC4 DIP switch location and
orientation