AMX TXC4 Series, Инструкция по эксплуатации, Страница: 21 / 24

TXC Wireless Transmitters Troubleshooting Guidelines 17
Troubleshooting Guidelines
Overview
Read through the following information (Figure 16) if you are experiencing a
problem with your TXC16+ or TXC32+transmitter. If the problem cannot be
resolved, call your AMX dealer. Refer to the Technical Support section of this manual.
Troubleshooting the TXC Wireless Transmitters
Problem Action
Red LED does not flash 1. Remove the transmitter’s battery cover and verify that
the batteries are correctly installed.
2. Verify that the batteries are fully charged using a
voltage tester. If not, replace the batteries.
3. If the transmission LED does not flash and one of the
following conditions are true, return the unit to your
AMX dealer for repair.
- RF system receiver responds correctly when you
press a transmitter pushbutton.
- IR receiver LED lights when you press a transmitter
pushbutton.
Red LED flashes but the AMX system
does not respond 1. Verify that positions 1, 2, and 3 of the DIP switch are
set to the correct transmit mode.
2. When using RF mode, verify that position 3 of the DIP
switch if ON (up).
3. Verify channel code transmission range (Figure 4)
matches the receiving control system’s program.
4. Hold the transmitter closer to the IR or RF receiver. If
the problem stops, the transmitter signals cannot reach
the control system due to high levels of IR or RF
interference or weak transmitter batteries.
- IR interference is typically generated by lights. Try
turning off room lights to check for improved performance.
- RF interference may be caused by electronic devices
such as computers, motors, lighting ballasts, wireless
microphones, etc. Move or reset the receiver’s position.
Figure 16
Troubleshooting the TXC
wireless transmitters