SA-132 Instruction Manual – Guide d’utilisation
Telephone Paging Input
This special input (terminals 1 and 3) will allow you to page in your PA system using your own telephone set. Pin
2 is Ground and Pin 4 is for manual priority switching. Any signal going through Pin 3 with automatically triggers
the priority system without any manual intervention. At the end of the announcement, the system will return to
its normal operation. A Gain control is located next to the input in order to increase incoming volume if
necessary. Final adjustment will be made with the Tel Paging volume control located on front panel.
Recommendations
Keep your amplifier away from excessive humidity, dust or grease. This unit has sensitive components that can
be affected in a difficult environment. If, at one point during its usage, the fuse on the AC line needs to be
changed make sure that the replacement is of the same value. It is important that you try to identify the reason
for this failure. This will most likely prevent further damage to your amplifier. Any service work on this unit
should be performed by a qualified technician.
Power saving feature
Note that this unit will automatically shut-off after a one-minute audio signal interruption.
SA-132 TECHNICAL SPECIFICATIONS
Output in RMS
130W
AC 117v 60Hz
4 Amp. Fuse
THD at Rated Power
2.5%
Speaker Outputs
4Ω, 8Ω, 16Ω, 70V, 100V
Frequency Response
100Hz – 20KHz
Microphone Input
1mV @ 600Ω
AUX Input
200mV @ 50KΩ
CD Input
500mV @ 50KΩ
Telephone Paging Input
100mV – 900mV (bal.)
Music on Hold Output
1W max @ 32Ω
Sig/Noise Ratio, Mic
>60dB
Sig/Noise Ratio, AUX/CD
>70dB
Tone Controls
±10dB
Dimensions HxWxD mm
90x430x270mm
Weight
10.5kg