AMX PT10-ADD, Инструкция по эксплуатации, Страница: 11 / 28

Installation and Wiring
7
PT10-ADD Additional Camera Pan/Tilt System
Mounting and Balancing the Camera/Lens
The camera/lens assembly should be mounted so that the tilt axis is capable of going through the
optical axis of the camera, assuming the optical centerline is between 1/2" (12.70 mm) and 5"
(127.00 mm) above the mounting plane of the camera lens. The mounting platform (camera cradle)
allows the camera/lens to be mounted with its center of gravity on the tilt axis. The maximum
weight of the camera/lens/cradle assembly is 10 lbs. (4.54 kg). The camera cradle is mounted to the
Tilt Hub (FIG. 5).
To mount and balance the camera/lens:
1. Separate the camera mount and cradle support bracket by removing the two 1/2" screws on the
underside of the assembly (see FIG. 6) using a 3/32" Allen wrench.
2. Install the camera alignment peg to the mount at the position that best fits the camera/lens.
3. Secure the camera/lens to the mount (at the camera alignment peg) with the 1/2" screw and
1/10" thick washer supplied (see FIG. 6).
IMPORTANT! READ THIS DOCUMENT BEFORE MOUNTING CAMERA.
Proper balance of the camera mount (with camera/lens/cradle) will result in optimal
performance. Follow these balancing instructions prior to operation. Failure to
balance the camera mount can result in poor performance.
FIG. 5 Tilt Hub dimensions
0.75"
(19.05 mm)
0.75"
( 19.05 mm)
0.75"
(19.05 mm)
0.25"
(6.35 mm)
0.25"
(6.35 mm)
0.75"
(19.05 mm)
0.00"
0.56" (39.62 mm)
Camera points in
this direction
Do not lift the PT10 by the Camera/Lens cradle as this procedure damages internal
components.