For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
9/12
©2012 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-0423-83
REV: B
WARNINGS!
•
The PS-POE-AF-TC should only be connected to devices compatible with
this product. Using the PS-POE-AF-TC with incompatible devices may
cause damage to the device.
•
Read the installation instructions before connecting the PS-POE-AF-TC
to its power source.
•
Follow basic electricity safety measures before connecting the
PS-POE-AF-TC to its power source.
•
A voltage mismatch can cause equipment damage and may pose a fire
hazard. If the voltage indicated on the label is different from the power
outlet voltage, do not connect the PS-POE-AF-TC to this power outlet.
Recycling and Disposal
Disposal instructions for old products. The WEEE (Waste Electrical and
Electronic Equipment) national environmental initiatives have been put in
place to ensure that products are recycled using best available treatment,
and recovery and recycling techniques, to ensure human health and high
environmental protection. Your product is designed and manufactured
with high-quality materials and components which can be recycled and
reused. Do not dispose of your old product in your general household
waste bin. Inform yourself about the local separate collection system for
electrical and electronic products marked by this symbol:
Use one of the following disposal options:
1.
Dispose of the complete product (including its cables, plugs, and
accessories) in the designated WEEE collection facilities.
2.
If you purchase a replacement product, return your older product
(including all components) back to the retailer. The retailer should accept
it as required by the national WEEE legislation.
Installing the PS-POE-AF-TC
The PS-POE-AF-TC may be placed on a desktop.
Preliminary Steps
•
Ensure that AC power is applied to the PS-POE-AF-TC, using an
operational ground connection.
•
Ensure that output Ethernet cable is connected to the DATA & POWER
OUT port.
•
Verify that a power-ready Ethernet-compatible device is connected.
Before placing the PS-POE-AF-TC:
•
Do not cover the device or block the airflow to the device with any foreign
objects. Keep the PS-POE-AF-TC away from excessive heat and
humidity and free from vibration and dust.
•
Ensure that the cable length from the Ethernet network source to the
terminal does not exceed 328 feet (100 meters). The device is not a
repeater and does not amplify the Ethernet data signal.
•
The PS-POE-AF-TC does not have a power switch. Simply plug the
device into an AC power source.
Installing the PS-POE-AF-TC
1.
Connect the PS-POE-AF-TC to an AC outlet (100-240VAC), using a
standard power cord.
2.
Connect the
DATA IN
jack (input) to the remote Ethernet network switch’s
Patch panel and the
DATA & POWER OUT
jack (output) to the terminal.
Pin Connections
FIG. 2 describes the PoE Gigabit pin-out connections for the IN and OUT
Ports on the rear panel of the PS-POE-AF-TC:
FIG. 2
PoE Gigabit pin-out connections
J2
J1
(Data IN)
(Power and Data OUT)
(rear of unit)
POWER (+)
DATA
Pins 4/5 (DATA + PWR)
DATA
Pins 1/2 (DATA only)
DATA
Pins 3/6 (DATA only)
POWER (-)
DATA
Pins 7/8 (DATA + PWR)
Note:
= Transformer
