AMX Precis DSP, Инструкция по эксплуатации

Страница: 24 / 43

Installation & Setup
18 Precis DSP Instruction Manual
3. Plug the other end of the serial cable into the serial port on the PC (or other serial controller/device).
4.
Open the serial communication software and set the port settings to
match the Precis DSP default settings (see table to the right).
The settings on the PC serial communication software and the enclosure
must correspond to each other. If a change is required to make them
match, change the PC’s settings.
The system is ready to install and open APGraphic EQ for initial setup.
Installing APGraphic EQ Software
Before installing, see the “PC Requirements for APGraphic EQ” on page 17.
To install and open the APGraphic EQ program:
1.
Close any software on the PC that could communicate with the Precis DSP over its serial port
(e.g., HyperTerminal).
2. Insert the AutoPatch CD with APGraphic EQ into the CD drive.
(If the CD does not autorun, explore the folder for APGraphic EQ.)
3.
If Java (JRE) v.1.4.2 is already installed on the PC, select the APGraphic EQ option without JVM.
If Java (JRE) v.1.4.2 is not installed, select the APGraphic EQ option with JVM.
4. Install the program according to the installer instructions.
5.
Open the program from the location specified during the installation (normally it is in the
AutoPatch Applications folder).
APGraphic EQ opens and discovers the system.*
The system is ready for a test switch; see page 19
* If APGraphic EQ does not discover the system, see below.
To discover the system (if APGraphic EQ does not):
1.
From the Comm menu, select Disconnect.
2.
From the Comm menu, select Settings. Set the correct Comm ID (port) and set the baud rate
to 9600.
Precis DSP
Serial Port Settings
Baud Rate 9600
Data Bits 8
Parity None
Stop Bits 1
Flow Control None
Balance slider
Output Device list
Reset for flat response
Mute/Unmute Button
Equalization
band sliders
Tone button
Status bar
Serial Port Setting Table for Precis DSP