AMX Corporation reserves the right to alter specifications without notice at any time.
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
036-004-2744 4/06 ©2006
AMX Corporation. All rights reserved. The AMX logo is a trademark of AMX Corporation.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-2255-05
REV: C
Attaching the NXT-BASE/1 to an NXT Modero Panel
1.
Power Off the panel before attempting to attach the NXA-BASE/1.
2.
Place the battery base (with battery) onto a flat/level surface.
3.
Turn the battery locking slider (FIG. 5) to one side until the locking
mechanism is horizontal to the base (going left to right) and the rear
battery latch is pointing directly outward (away from the LCD).
4.
Carefully angle the NXT-CV7 panel over the front alignment pegs
(FIG. 6). The pegs assist in both aligning and securing the panel to
the base (the locking mechanism secures the base to panel when
done).
5.
Insert the alignment pegs into their corresponding holes below the
front of the panel.
6.
Verify the alignment of the Panel Interface connectors between the
panel (female connector) and base (male connector) (FIG. 6).
7.
Align the rear pegs and gently push the rear of the panel downwards
until it is mounted atop the battery base.
8.
Slide the rear battery locking slider in the opposite direction. This
turns the latching mechanism and secures the panel to the base.
ATTENTION!
The battery base CANNOT be hot-swapped. An NXT can not be receiving
power (through a connected power supply) and then be connected to a
battery base. Always POWER OFF the panel before installing the
NXA-BASE/1.
9.
Upon successful connection, the AMX logo appears on the panel to
indicate that the panel is properly connected and receiving power.
Charging the NXT-BP using the NXA-BASE/1
1.
Insert the single battery into the battery compartment shown in
FIG. 5.
2.
Follow the procedures from the previous sub-section to attach the
NXT-CV7 to the NXA-BASE/1.
3.
Insert a 2-pin connector from a power supply to the rear PWR
connector on the NXT-CV7 Modero panel.
FIG. 5
NXA-BASE/1 showing Panel Interface and connector locations
FIG. 6
NXA-BASE/1 shown aligning with an NXT-CV7 panel
Panel Interface
connector (male)
Securing
pegs (2)
Front
Back
Battery
locking
mechanism
Battery
locking slider
Insert holes for
NXT-CV7 feet
Alignment
pegs (2)
Panel Interface
connector
Alignment
pegs
Battery
locking
mechanism
(female)
(with locking
slider)
