Encoder Configuration Options
33
N2412A/N2422A User Manual
HDMI Pass Thru Settings
The section of the
Settings
is displayed when you click the
HDMI Pass Thru Settings
link. Options are
FIG. 28
HDMI Pass Thru Settings
TABLE 8
Settings Page: Software Section
Option
Description
Model
Displays the model number of the N2400 Encoder.
Serial
Displays the serial number of the N2400 Encoder.
MAC Address
Displays the MAC address of the network interface of the N2400 Encoder.
Firmware Version
Displays the date code for the currently running version of the N2400 Encoder internal firmware.
Web Version
Displays the date code for the currently running version of the web interface.
Factory Restore
Click to restore the device to the original factory settings. This resets everything except the IP address
(including name, stream number, serial settings, etc.).
Reboot
Click to begin a software reboot. This command does not initiate a full power cycle and does not affect the
current configuration.
TABLE 9
Settings Page: HDMI Pass Thru Settings
Option
Description
HDMI Pass Thru
Enables looped output.
Enable HDMI Audio
Determines if the unit will output audio over the HDMI connection. Selecting
Auto
bases audio output on the
settings of the connected source device.
YUV Output
For color conversion. Can force to RGB output based on connected device’s reported settings. Default (and
preferred setting) is
Off
.
Simplified HDMI Detect
When enabled, detects HDMI solely based on the hot plug detection. Enable to help prevent displays/monitors
from going to sleep.
Invert HDMI Sync
Inverts horizontal and vertical synchronization to the output display. Used for non-standard displays.
Video Mute
When enabled, the output video stream is forced to black screen.
Cancel
Click to return all controls to the last saved configuration.
Save
Click to accept changes made to these controls.