10
Introduction
Landmark Cinema Quick Setup Guide
Making the Cables
Use Category 5 (CAT-5) wire for all PhastLink connections. CAT-5 wire consists of
4 twisted pairs of wires. An RJ-45 connector is used at each end.
T568A Wiring Standard (PhastLink Cables)
The cables between the PMB-RF, PMB-TCC, and PMB-CF2 are CAT-5 PhastLink
cables. These cables use the T568A wiring standard for the RJ-45 pin connections at
BOTH ends of each cable. These connections are shown in Figure 8:
CAT-5 PhastLink cables (T568A Wiring Standard)
Pin
Wire
PIN1
White/Green
PIN2
Green
PIN3
White/Orange
PIN4
Blue
PIN5
White/Blue
PIN6
Orange
PIN7
White/Brown
PIN8
Brown
T568A-to-T568B Wiring Standard (NULL 10-BaseT Ethernet Cable)
The cable between a computer's Ethernet card and the PLC-MCU card (in the PMB-
CF2) is a CAT-5 10-BaseT Ethernet cable that uses the T568A standard at one end of
the cable and the T568B wiring standard at the other end of the cable. It does not
matter which end is plugged into which device, as long as one end is wired one
way and the other end is wired the other way.
NULL 10-BaseT Ethernet Cable (T568A to T568B Wiring Standard)
Connections at One End (T568A)
Connections at the Other End (T568B)
PIN1
White/Green
PIN1
White/Orange
PIN2
Green
PIN2
Orange
PIN3
White/Orange
PIN3
White/Green
PIN4
Blue
PIN4
Blue
PIN5
White/Blue
PIN5
White/blue
PIN6
Orange
PIN6
Green
PIN7
White/Brown
PIN7
White/Brown
PIN8
Brown
PIN8
Brown
Important!
There are TWO different
wiring standards used in a
Landmark Cinema system.
Depending on what devices
are being connected, you
must select the proper
standard, as explained below.
Figure 8
CAT-5 PhastLink cable
connections at both ends
(T568A wiring standards)
Note
If you are connecting the
PLC-MCU card to an Ethernet
hub instead of to an Ethernet
card in a PC, use a straight-
through, pin-to-pin cable.
Figure 9
NULL 10-BaseT Ethernet
Cable (T568A to T568B
Wiring Standard)
Содержание Landmark Cinema
Страница 1: ...instruction manual Landmark Products Landmark Cinema...
Страница 4: ...ii Table of Contents Landmark Cinema Quick Setup Guide...
Страница 13: ...Landmark Cinema Quick Setup Guide Introduction 9 Figure 7 Mapping the wiring to the IR emitters...
Страница 15: ...Landmark Cinema Quick Setup Guide Introduction 11...