AmTryke AM-12, Руководство по сборке, Страница: 9 / 23

Revised 11/1/12 7
AM-12S, AM-12 & AM-16
You need the following tools for assembly (too see a picture of different tools,
see page 22):
Front Wheel
Start assembling your tryke by first attaching the front wheel assembly to the
main frame. Choose which of the
three front wheel positions your rider
will best utilize (vertical or middle
position, or wheel fully extended).
To attach the front wheel assembly:
1. Install the lower quick release lever
to one of the holes and a thumb nut
on the opposite side.
2. Next, put one end of the steering
centering spring on the eyelet on the
main frame and slide a protective
cover over the spring.
3. Use a long screwdriver, pliers or
small pry bar to attach the other end
of the spring to the eyelet on the
front fork as shown.
4. Insert the upper quick release lever
and thumb nut on the opposite side.
Push levers down flat against the
frame.
NOTE: Chain guard is on the
right side of tryke.
Steps 1 and 2
Quick
release lever
Spring
cover
Spring
Eyelets
NOTE: This can be difficult and
requires some strength.
Step 3
Quick
release
levers
TOOLS REQUIRED:
•
4 mm Allen wrench
•
10 mm wrench/socket
•
14 and 15 mm wrench (incl.)
• 22 mm socket or adjustable wrench
•
Quick release wrench (incl.)
•
Screwdriver/pliers
Step 4
NOTE: AM-12S does not have a
hinged front end.