AmTryke AM-12, Руководство по сборке, Страница: 13 / 23

Revised 11/1/12 11
AM-12S, AM-12 & AM-16
Models
AM-12 and AM-16 feature a saddle seat (If
your model is AM-12S , see instructions after these):
1. Install the saddle seat onto the seat post.
2. Align the seat with the front of tryke and tilt to
preferred position. Tighten the seat clamp
equally on both sides with a 14 mm wrench.
3. Install the lap strap by threading it through slots
in the bracket at the back of seat post assembly.
To install snappy seat ( AM-12S ), place the seat on top of the seat post and align
the holes in the seat post with the holes
in the seat. Use a 4 mm Allen wrench to
tighten screws.
To install the seat back onto the seat
back support rod:
1. Remove the two knobs and washers
from the seat back.
2.
Add the larger fender washer and
tighten the knob. Choose whichever
slots best fits the rider.
NOTE: Be sure the seat is fully seated onto the post.
Saddle seat and seat back
NOTE: Straps thread through
the back of seat back.
NOTE: The slot at the bottom of the
seat back fits over the support rod.
The screws fit through the seat back
and the slot between the rods.
Knobs
Screws
Seat back
Snappy seat pictured from bottom
Straps