6
The height character "H" on the screen will blink showing the next measurement to take. Press
READ key to take heipt measurement, the result will be displayed on upper portion of screen.
(Step 3);
Then the volume is automatically displayed on the lower portion of the screen;
Pressing the READ key again will toggle back and forth between the length, width and height
measuremem on the upper portion of the screen;
Press SET key to clear the data on the portion of the screen, and then can begin the new
calculation of volume;
To choose measurement mode, press SET key again.
Tips:
Press the SET key one by one will toggle back and forth between the length, area, volume and
length measurement. If there are datum on the display, first pressing the SET key will clear the CllITelll
datum, and the mode will be invariable.
Addition of volumes under volume mode:
Press M key to save the calculated volume of first time measurement, and the "M+" icon will
appear on LCD;
Press SET key to clear the current displayed data, then can begin the second time
measurement and computation (Follow step 1 to 3 under the volume section).
After getting the calculated volwne of second time, press key to enter the addition mode. A "+"
icon would appear on LCD;
Press RM key to recall the first calculated volume for the addition. The "M+" icon will
disappear and the stored memory will be automatically cleared;
Press =/+ key, the awn of both volumes is shown on the lower portion of the screen.;
Repeat the steps above to keep adding the measured volume.
Temperature display
Press and hold SET key and at the same time press the RM key, the envirorunent temperature
will appear on the lower portion of screen (the unit is oC if the distance unit is M, while the unit is
oF if the distance unit is ft/in), and press the READ key again to return the measuring state.
