AMT 569 Series, Спецификация, информация и руководство по ремонту запасных частей

Страница: 3 / 8

Specifications Information and Repair Parts Manual
569, 570, 571, 572 Series
5690-250-00 3 11/2012
soapy water. Slide casing onto adapter. Set casing in position by taping
on casing bottom with a rubber mallet until casing slides by seal and seats
on adapter flange.
10. Attach casing using fasteners. Spin motor shaft to check for interference
with casing.
Seal will produce minor drag when spinning motor shaft, but rubbing
anywhere else must be eliminated! Otherwise, damage to pump and/or
motor may occur.
PUMP PIPING
1. Proper system design and installation by a qualified engineer is
recommended.
2. Always start piping from pump.
3. Use as few bends as possible and preferably long radius elbows.
4.
Do not use flexible connectors on the suction or discharge of a vertical in-
line pump unless the pump is rigidly mounted to a foundation.
5. Ensure piping exerts no strain on pump as this could distort the casing
causing breakage or early failure due to pump misalignment.
6. All connecting pipe flanges must be square to the pipe work and parallel
to the pump flanges.
7. Eliminate all air pockets that may prevent the pump from operating
effectively.
8. In open systems, test suction line for air leaks before starting; this
becomes essential with long suction line or static lift.
9. Install valves in both suction and discharge lines to assist with pump
inspection or repair. Suction line valve may be opened completely during
operation.
10. Install a non-slam non-return check valve in discharge line between pump
and isolation valve to protect pump from excessive back pressure and to
prevent water running back through the pump on open systems.
11. Before starting pump, the system must be thoroughly cleaned, flushed
and drained and replenished with clean liquid.
12. Welding slag and other foreign materials, improper or excessive
water treatment are all detrimental to the pump internals and sealing
arrangement and void warranty.
13. Proper operation cannot be guaranteed if the above conditions are not
adhered to.
NOTE: INSPECT THE FOLLOWING BEFORE PUTTING PUMP INTO
OPERATION:
1. Pump primed; liquid in pump.
2. Rotation.
3. System piping and pump properly supported.
4. System clean of all debris.
5.
Proper electrical connections. Consult qualified electrician with any
questions.
6. Proper motor support is required to avoid damage to motor or pump see
page 1, Installation & orienting sections
IMPORTANT: SYSTEM MUST BE FREE OF ALL PETROLEUM BASED
LIQUID OR SUBSTANCE TO AVOID SEAL FAILURE, WHICH CAN ALSO
LEAD TO PREMATURE MOTOR BEARING FAILURE. FAILURE TO
COMPLY VOIDS WARRANTY.
Patterson/AMT Inline Circulator Pump