AMSAN AM-FPL9, Руководство пользователя

Страница: 16 / 28

15
Four post parking lift AM-FPL9
the lock lever down on each side of the cross rail and slide
the cross rail down until it rests on the safety lock position
closest to the floor. Repeat the procedure for the front posts
to install the cross rails. Stand the assembled posts up in
positions indicated on the floor plan.
⚫
Start with installing runway that has cylinder already
installed in it. This runway will be placed on the cross rail
with the hose Connection facing out toward the power side
post. With an assistant, pick up and place one end of the
runway on the cross rail, and then pick up and place the other
end on the opposite cross rail (if you have three assistants,
place both ends at the same time). Use a large screwdriver or
aligning punch to align the mounting holes in the cross
rails with the mounting holes of the runway. Do not leave the
tracks unbolted
– install the mounting bolts immediately!
Install M12X100 mounting bolts and M12 washers thru the
ramp brackets and wheel stops. Make sure the bolt head is on
the flat side of the bracket. Install the two ramp brackets and
two wheels stop with bolts and washers as you secure the
main runway to the cross rail. Secure the bolts with M12
washers and nuts placed hand tight. Now, install the offside
runway and again secure with ramp brackets, wheel stops
with M12X100 bolts and nuts. After both runways are
installed, tighten all bolts M12X100 bolts.
⚫
Install the cylinder connecting metal plate as shown in below
figure. Reference this diagram for installing cables.