AMS 28 Slim Gem, Руководство по эксплуатации и обслуживанию

Страница: 25 / 51

L0126J
19
3. The “fin” shaped portion is angled towards the front
of the tray.
The best position and angle for the ejector is determined by test
vending products.
HELIX ALIGNMENT DEVICE
The helix alignment device is installed under the bottom left side
of the large helices to help keep them centered in their columns.
1. To remove, grasp the front of the helix alignment
device with pliers and pull or pry upward. Take
care not to lose the plastic mounting clips.
2. Reinstall by pressing the plastic mounting clips
back into the mounting holes. Note that the
mounting flange goes toward the helix.
MOTOR POSITIONS / HOME
Motor position can be changed sideways for different width
columns, and there are two mounting positions on the snack
tray. The lower and upper positions are used for the small and
large helices, respectively.
1. Remove the helix. Remove the harness terminals
(one small and one large).
2. Press down and rearward on the top mounting tab,
then pull the lower mounting legs out of the
mounting slots.
3. Reverse the removal procedure to reinstall.
4. After all motor changes have been made use the
Tray Setup option in Service Mode to configure the
motors.
5. The vendor will not vend from a given helix when
the motor is missing, jammed or has home switch
problems.
6. After a motor has been configured check to make
sure all the helices are in the home position. If the
end of a helix is not at its lowest position in the
column pull it out of the motor, turn it until it is, and
reinsert the helix into its motor.
BOTTLE TIPPER BAR
The bottle tipper bar is typically used with carbonated beverage
bottles. The bottles stand upright. The tipper bar restrains the
top of the bottle so that it falls bottom first, rather than tumbling
off the tray.
1. To remove, bow the bar until one end can be
pulled free from the support bracket. Take care not
to lose the plastic bushings in the supports.
2. To reinstall, reverse the removal procedure.
AVOIDING PRODUCT HANG-UPS
Avoid large products, such as chips, from “hanging-up” between
the tray and the glass by loading them “left corner first” into the
helix. The bottom left corner of the bag should be in front of the
helix to let the helix push the bottom out first (Refer to
Figure 5.2
below). An incorrect loading may cause the bag to fall top first,
which could lead to a hang-up. Loading “left corner first”
prevents the product from falling top first.
TALL PRODUCT VENDING
Place tall, narrow products in a column with a candy pusher bar.
Rotate the bar upward or downward to the desired position. It
should hold the product upright, but not pinch or bind the
product.
Figure 5.2 Large Bag Vending
5 TRAY ADJUSTMENT AND CONFIGURATION