Amrex MS322, Руководство пользователя

Страница: 23 / 30

MS322 User's Guide 15
MS322 General Operation and Application Procedures
Application of Electrical Muscle Stimulation
Electrical muscle stimulation, high voltage or low voltage ac, is usually applied
through carbon type pad electrodes with disposable cloth covers, or sponge type
pad electrodes. The Flextrode System has been designed for the application of
electrical stimulation with the use of carbon type electrodes.
The Flextrode pad electrode must be used with the Flextrode disposable cloth
cover. The cloth cover provides added hygienic protection and increased
conductance to the patient. To obtain maximum conductivity, it is important to
properly prepare the Flextrode pad electrode and cloth cover before application
of electrical muscle stimulation.
The Flextrode pad electrode and cloth cover assembly must be completely and
thoroughly moistened by immersing it in water. Apply a generous amount of
Flextrode Conductive Spray to the moistened cloth cover. If the Flextrode
Conductive Spray is not desired, apply a generous amount of Amrex Conductance
and Coupling Gel to the thoroughly moistened Flextrode cloth cover. A generous
amount of Flextrode Conductive Spray or Amrex Conductance and Coupling
Gel is required to insure good conductivity. Thoroughly clean pad(s) with warm
water after each treatment and dispose of the used cloth cover(s).
Important
It is the personal responsibility and obligation of the user to verify that patient
cords and electrode pads show no evidence of deterioration prior to patient
application. When such evidence exists, replace the cords or electrodes. Never
sharply bend or twist the cords. Loose connections or broken cords can cause
poor conductance and possible discomfort to the patient.
Should the patient complain of low stimulation output, no output or sudden
irregular increases in output, immediately discontinue treatment. Check for the
following: secure cord connections; proper electrode contact with the patient;
electrode wear or lack of cleanliness. Replace patient cords and/or pad electrodes
that show any evidence of deterioration.