9
R1. RCA outputs
: for connection of RCA interconnection cables.
R2. XLR outputs
: for connection of XLR interconnection cables.
R3. INPUT
: to select EITHER Direct (single input) or Normal (multiple inputs) vinyl source/sources respectively.
R4. USB output
: to use the built-in USB Analogue-to-Digital Converter.
R5. GROUND post
: to connect turntable/phono cable ground wire/s.
R6. DIRECT input
: to connect a cartridge bypassing the multiple input switching.
R7. LOAD
: RCA connectors to allow custom loads to be attached to the Direct input.
R8. INPUT 1-3
: RCA inputs, for signal input from up to three vinyl sources.
R9. GROUND post
: to connect turntable/phono cable ground wire/s.
R10. IEC power connector
: for the connection of a PC-77 mains power cable to the PH-77.
R11.
POWER
: to switch on mains electricity to the PH-77.
In the majority of audio systems, the PH-77 is most likely to be operated in direct input mode: please inspect the rear panel
of the PH-77 to verify the following:
- INPUT
switch is set to
DIRECT
The cable from the turntable MUST be attached to the Direct input.
If more than one turntable is used in the system or more than one tonearm/cartridge combination is mounted on a single
turntable, verify the following:
- INPUT
switch is set to
NORMAL
The cables from the turntables/tonearms MUST be attached to the numbered inputs and the Direct input MUST remain
unconnected!
WARNING:
Always turn off
power to the
PH-77 before
switching
between direct
and normal in-
puts (R3) or
before making
or changing
any
connections
Note:
Direct AND
Normal inputs
must not be
connected
simultaneously
