Amptec Research 620A SERIES, Руководство по эксплуатации и обслуживанию

Страница: 19 / 27

Detailed Description
Analog Section
Figures E2 diagrams A thru D shows the
equivalent circuit of the analog section in
three different phases of operation. The
system will perform conversions at a rate
determined by the clock frequency 40,002
clock periods per cycle. (see Figure E1B
shown earlier in this section for details of
conversion timing).
Auto-Zero Phase I (Figure E2A)
During the Auto-Zero, the input of the buffer
is connected to V REF through switch 2, and
switch 3 closes a loop around the integrator
and comparator, to charge the Auto-Zero
capacitor until the integrator output dose not
change with time. Also, switches 1 and 2
recharge the reference capacitor to V REF.
Input Integrate Phase II (Figure E2B)
During Input Integrate the Auto-Zero loop is
opened and the Analog Input is connected to
the Buffer Input through switch 4 and C
REF. If the input signal is zero, the buffer,
integrator and comparator will see the same
voltage that existed in the previous state
(Auto-Zero). Thus, the integrator output will
not change but will remain stationary during
the entire input integrate cycle. If V
IN
is not
equal to zero, and an umbalanced condition
exists compared to the Auto-Zero Phase, the
integrator will generate a ramp whose slope
is proportional to V
IN
.
Deintegrate Phase II (Figures E2C and
Figures E2D)
During the Deintegrate phase, switch 5 is
closed and a voltage which is V REF more
positive than during Auto-Zero is impressed
on the BUFFER INPUT. Thus
the referance
capacitor stores the equivalent voltage. This
returns the output of the integrator to the
zero crossing point established in Phase I.
The time, or number of counts required to do
this, is proportional to the input voltage.
E-4-1. Reference Voltage
The precision reference voltage required to
do the A/D conversion is developed by
IC201. The zener voltage is attenuated to
approximately -0.5V . This voltage is
applied to IC2-7 .
E-4-2. LED Display
The output format from IC2 is in Binary
Coded Decimal (BCD) format. Each digit is
scanned for 10 clock pulses. The scan
sequence is D5 D4 D3 D2 D1. This drives
Q1 thru Q5, which in turn drives the seven
segment displays. The BCD data is
converted to seven segment format by IC4.
When the 620A electronics are in open
circuit or over-range mode, the display
flashes “
0000"
. IC5 is a 1 MHz
oscillator which is divided by 10 by IC6.
The 100 KHz clock output then goes to IC2.
E-5. Ohms-to-DC Converter
The ohms-to-DC converter generates a
constant current which is passed through the
device under test to develop the voltage
measured by the A/D converter.
E-5-1. Constant Current Source
The constant current source is composed of
IC201, IC202, Q202, D203 and their
associated components. The input to the
constant current source is approximately
+1.05 volts, developed at IC201-7 and
connected to IC201-13 through R209 and
R210.