17
Auto Power Off (APO)
The Auto Power Off (APO) mode turns the meter off automatically to extend battery life
after approximately 17 minutes of no activities. Activities are specified as: 1) Rotary
switch or push button operations, and 2) Significant measuring readings of above 10%
of range or non-OL
readings. That is, the meter will intelligently avoid entering the
APO mode when it is under normal measurements. To wake up the meter from APO,
press the SELECT button momentarily or turn the rotary switch to the OFF position and
then turn back on again. Always turn the rotary switch to the OFF position when the
meter is not in use
Disabling Auto Power Off
Press the RANGE button while turning the meter on to disable the Auto Power Off
(APO) feature.
5) MAINTENANCE
WARNING
To avoid electrical shock, disconnect the meter from any circuit, remove the test leads
from the input jacks and turn OFF the meter before opening the case. Do not operate
with open case. Install only the same type of fuse or equivalent
Cleaning and Storage
Periodically wipe the case with a damp cloth and mild detergent; do not use abrasives
or solvents. If the meter is not to be used for periods of longer than 60 days, remove
the battery and store it separately
Trouble Shooting
If the instrument fails to operate, check battery, fuses, leads, etc., and replace as
necessary. Double check operating procedure as described in this user’s manual
If the instrument voltage-resistance input terminal has subjected to high voltage
transient (caused by lightning or switching surge to the system) by accident or
abnormal conditions of operation, the series fusible resistors will be blown off (become
high impedance) like fuses to protect the user and the instrument. Most measuring
functions through this terminal will then be open circuit. The series fusible resistors and
the spark gaps should then be replaced by qualified technician. Refer to the LIMITED
WARRANTY section for obtaining warranty or repairing service.
