Amplicomms TV Soundbox, Руководство пользователя

Страница: 26 / 91

Helpline UK 0844 800 6503
(See page 26 for costs and hours of operation)
Using as a stand-alone speaker
Connect the audio source as depicted.
To save battery capacity you can con-
nect the transmitter’s AC adapter to the
receiver. Please remember to re-con-
nect it to the transmitter, if you finished
the stand-alone speaker mode.
Troubleshooting
No sound
- Ensure that the mains adapter is pushed fully into the power outlet and
that its cable is properly connected to the DC IN connector on the trans-
mitter.
- Ensure that the receiver power ON/OFF switch is switched to ON.
- The charge level of the battery inside receiver may be too low. Recharge
the battery.
- Ensure that the TV set, Hi-Fi system or audio component is switched ON
and set to a channel that broadcasts an audio signal.
- If you pick up the audio signal for the transmitter from a headphone jack
on the audio source, please check whether this output is controlled by a
volume control. If necessary, turn this output volume higher.
The radio connection between the transmitter and receiver is defective.
In a few cases, external influences can lead to interruptions in the radio con-
nection between the transmitter and receiver. In this case you can then pair
the receiver with the transmitter with the following steps :
1 Ensure that the transmitter is operating (power indicator on).
2 Press and hold down the pairing button on the rear panel of the trans-
mitter for approx. 2 s, until the power indicator flashes).
O
PERATION
21