Ampler – Curt
36
Cleaning, maintenance and care
Changing tires
Switch off the Pedelec.
Removing the rear wheel
A video about this is available on the
Ampler Support Portal
. The video explains the necessary
assembly steps in detail and contains further tips.
ATTENTION
Damage is caused to the motor cable and drive by wrong disassembly!
Make sure that the motor cable is disconnected at the rear wheel.
1. Disconnect the motor cable at the plug.
2. Remove the right hand nut and washer and take out the wheel.
3. Remove the tire from the wheel with a suitable tool.
4. Mount a new tire.
5. Reinstall the wheel. Keep the following in mind:
6. Bring the rear wheel approximately into position.
7. Place the belt on the sprocket or the chain on the cassette. Pull the derailleur back by hand if necessary.
8. When the belt or chain is correctly positioned on the sprocket or cassette: Insert the rear wheel into the dropouts
and tighten the nuts provisionally.
9. Check that the rear wheel is secure and tight in the dropout.
10. Inflate the tire.
11. Put the wheels on the ground and loosen the rear axle nuts again.
12. Put some load on the saddle.
13. The rear wheel is pushed firmly into the dropouts.
14. Tighten the nuts firmly. Pay attention to the tightening torque. Where applicable, use a torque wrench.
15. Check the clearance to the fender and stays.
16. Check that the rear brake does not drag.
17. Reconnect the motor cable at the plug.
Replacing tires
Only use tires of the same dimension and with reflective sidewalls.
or
When using tires without reflective sidewalls: Install spoke reflectors.
