27
Before the first ride
Ampler – Curt
Selecting assist mode
Pedelec is switched on.
If the display is off then it can be “woken up” by a short press on the power button. We recommend
not
to do this while riding.
The display shows the active state.
1. Shortly press the power button to cycle between modes.
2. The display shows the following icons:
y
for standard mode
y
for max mode
y
for 0% assistance mode
3. Select the desired mode. The icon will be shown for approx. 2 seconds and the mode is set.
6.3.3 Switching the lights on and off
DANGER
Trying to press the power button while riding can cause an impairment of balance
Stop the ride to operate the power button.
Falls and crashes can occur when concentrating too much on the display operations while riding.
Keep the focus on the road ahead and your surroundings while riding.
The lights (front light and rear light) are powered by the battery. The front and rear lights are switched on and off together.
The Pedelec always remembers the last selected setting (lights on or off).
Switch light on / switch light off
Pedelec is switched on.
The display shows the active state.
1. Press and hold the power button.
y
The display shows the lights icon for approx. 2 seconds
2. Release the power button while the icon is displayed.
y
The lights switched on
Repeat the process to switch the lights off.
1. Press and hold the power button for 1 second.
y
The display shows the lights off icon for approx. 2 seconds
2. Release the power button while the icon is displayed.
y
The lights switches off
If you want to ride with lights on but without motor support then turn the lights on and select 0% assist mode.
