CLEANING
• Unplug the product before cleaning.
• When the system gets dirty, wipe it with a clean, soft cloth. If necessary,
wipe it with a soft cloth, slightly dampened with soapy water. Wipe dry
immediately with a dry cloth.
• Never use benzene, aerosol cleaners, thinner, alcohol or any volatile
cleaning agent.
• Do not use abrasive cleaners, as they may damage the finish.
SERVICE
• Do not open the cabinet of any components. Opening the cabinets may
present a shock hazard, and any modification to this product will void
your warranty.
• Do not attempt to service the unit yourself.
• Please refer any service to an authorized Amphony service center.
User and Installation Guide
User and Installation Guide
Pairing the receiver with the transmitter
In order to receive audio, the receiver must first be paired with your iFinity audio
transmitter.
Press the pairing button of your iFinity Model 800 transmitter (please refer to your
iFinity transmitter user manual for further details). The transmitter network status
light will start flashing quickly.
Press the pairing button of your iFinity wireless audio receiver within 5 minutes.
This button is located at the bottom of the receiver (please see picture on next
page). Once the receiver locks to the transmitter signal, the receiver network status
light will light continuously. You now should be able to hear the audio.
You can pair up to 4 wireless receivers with one transmitter. Pair each wireless
receiver as shown above.
Description of the receiver network status light
Flashing Slowly:
Not paired to any transmitter signal
Flashing Quickly:
Pairing Mode
Always On:
Audio is being received
Page 11
ATTENTION!
Do not connect the receiver to passive speakers! Use the Model 880
Wireless Audio amplifier to connect to passive speakers.
Page 4
Selecting the audio channels
Select the wireless audio channels which the receiver should receive by using a
small screwdriver and toggling the red switch at the bottom of the receiver.
