Parts Identification
2
PAGE 2
iPX5400 | ETHERNET TRANSCEIVER
3
6
7
1
1. INDICATOR LEDS
Front View
Rear View
9 10
5
4
8
R
LEDs for Power : Blue ( DC power connected), Server (when network connection established) , Status (when transmitter
and receiver communicates ) and Streaming ( When transmitter is sending data / audio ).
2. POWER PORT
24V DC power supply input.
3. ETHERNET PORT
Ethernet Port for connection to network switch.
4. RESET BUTTON
Press to enable iPX5400 to enter bootloader mode or reset the unit to factory settings.
Bootloader mode : Press and hold until Power, Server and Status LEDs lit. This mode enables firmware updating if
normal updating not possible. All data saved previously will remain.
Reset mode : Press and hold until Power, Server, Status and Streaming to reset the unit. All data will be lost.
5. RELAY CONTACT
Activating transmitter remote trigger will activate receiver Relay Contact with NO. Can be used as E/M relay contact to
override signal or to trigger All Call
6. REMOTE TRIGGER PORT
This contact from transmitter when closed shall trigger Relay Contact at receiver
7. RS485 PORT
For RS485 data transmission from PD paging mic to activate zone decoder / selector connected with receiver.
8. SIGNAL INDICATOR
Signal indicator for audio signal which will blink according to the audio level.
9. AUDIO INPUT PORT
Connect audio input with balanced line level from paging mic or other BGM source.
10. AUDIO OUTPUT PORT
Output received shall be balanced line level, to connect to external mixer, amplifier, etc.
