FI6000 | FIRE ALARM INTERFACE
PAGE 5
Connection Diagram
PSU (24V DC)
PS9400 with UPS
or Back Up Battery
~
~
To TD6240 / TD6080
/ MR1301
Terminate with 120 Ω resistor
Dry contact (MR1301 /
EP1200 or any other
applications required)
Dry contact for Fire Alarm
System / Sensor etc.
Application Note:
Although FI6000 is intended to be used with Fire Alarm System, its application is not limited as specified. It can be used as a tool
to generate a sequence of functions by using the dry contacts available. It is a tool similar to a miniature PLC unit.
If the device connected to PC this info shall appear.
Address of the unit
Destination port on the PC
States version number at firmware
FI6000 Icon
Device Setup (PC Interface)
Connect your PC to FI6000 via USB cable provided, and the main page shall appear as shown in the next page.
At the upper right corner of the page, a table shows the information about the unit's version.
Note:
Ensure correct polarity A and B
The Configurator Software for FI6000 is available from website / download. Download the
package to your PC and run " FI6000 Setup " file.
Should you encounter interruption during download, please disable any active Anti Virus
software temporarily. An icon shall appear at your desktop.
