7/10
www.amp-research.com
A M P R E S E A R C H P O W E R S T E P – F O R D F 1 5 0 S U P E R C R E W
IM2996 rev 11.27.06
Remove the front radiator shrowd to access clear
routing for Power Step wire harness.
Route the long harness end and power hook-up
end of Power Step wire harness along front
edge and secure with tie wraps along the way.
4
After removing Power Step harness fuse, attach
ring terminal of the red wire to the positive
battery lead and that of the black wire to the
negative battery lead.
4
Route harness end with motor connectors
down the inner side walls of truck and down
along the frame to the motorized linkages. Plug
connector into motor.
4
3
Pierce holes in front floor board grommets to allow
access for harness trigger wire into cab of vehicle.
Push purple trigger wires through pierced holes.
Grommet
Trigger Wire
4
After pushing/pulling wire slack through grommet,
apply some silicon sealer to hole in grommet.
Secure any loose wires with tie wraps and/or electri-
cal tape.
13
14
15
16
17
18
