5/10
www.amp-research.com
A M P R E S E A R C H P O W E R S T E P – F O R D F 1 5 0 S U P E R C R E W
IM2996 rev 11.27.06
Install U-Nut. Drilling Rear Mounting Holes: Posi-
tion and clamp drill template as shown, (center on
U-Nut) and pilot drill mount holes with 1/8” drill bit.
Remove template and drill holes to 21/64”.
8
13
1.2”
rear of vehicle
Note: Steps 1-9 show Driver’s Side.
Install U-Nut. Drilling Forward Mounting Holes:
Position and clamp drill template as shown,
(center on U-Nut) centering the template
around stock mounting hole.
13
front of vehicle
3
Mounting Rear Brackets: Install two u-nuts if
not already present. Install support bracket and
then install Rear Bracket. Do not tighten bolts
yet.
9
12
15
Position Idler Mount at rear mount location and
bolt to bracket and drilled mounting holes.
Snug all bolts... do not fully tighten.
14
11
2
Mount Front Bracket to upper stock mounting
hole that the drill template was centered about.
10
15
Position motor linkage assembly in forward
mounting position and bolt to bracket and
drilled mounting holes. Snug all bolts... do not
fully tighten.
11
14
3
1
2
3
4
5
6
