AMP MAKER N5X, Руководство по монтажу

Страница: 14 / 40

14 N5X Construction guide
Turret board mountings
Next, add the hardware for mounting the two turret boards. There are nine 3mm holes altogether, shown
here. In each case, add a 6mm M3 screw from the outside, then a shakeproof washer on the inside, then
one of the M-F spacers to secure it in place.
Now check that both of the turret boards mount on these spacers. There's a little tolerance ('wriggle
room') built into the mounting dimensions, so if necessary you can loosen one of the M-F spacers and
adjust it slightly in its hole. At this point, do not fix the turret boards in the chassis. We'll get to that later.
Other lightweight hardware
In general, it's a hell of a lot easier to handle a chassis-assembly job if you keep it as light as possible for
as long as possible. For this reason, add the other lightweight parts first and the heavy transformers
later. Here's the simpler stuff, in no particular order:
* V1 valve socket using M2.5 hardware
* V2 valve socket and retaining clip using M2.5 hardware
* V3 valve socket and retaining clip using M3 hardware (6mm screw)
* 3-way tagstrip using M4 hardware