
10
N5X Construction guide
Along the top, there's your guitar signal path from left to right:
* green box = guitar input, first amplification stage and Gain control
* yellow box = second amplification stage and TMB tone controls
* red box = Master volume and power stage
Along the bottom, there's the power supply, with the mains entering at bottom right:
* grey box = mains-side circuit
* orange box = heater supply for the valves
* blue box = power supply with VCB
First amplification stage
The guitar input socket is shown at the top left, and it feeds into the
light green shaded section. This is the first stage of the amplifier and
it uses one half of the ECC83 preamp valve (V1a) to amplify the low-
level guitar signal.
The resistors and capacitors around V1a set the way that it works
- how much current flows at idle and what EQ is applied to the signal passed along to the next stage.
There's also one half of the Boost switch (S1a) here - it controls which is any capacitors are used to add
an extra boost to part of the guitar signal.
The final part of this section of the circuit includes the Gain pot, which controls how much of this
boosted signal is fed into the second stage.
Second amplification stage
The guitar signal - still fairly clean so far - is fed into the second part of the
amp (shaded in light yellow in the block diagram). This uses the other half of
the ECC83 preamp valve, V1b. Many of the components are similar to the first
stage, and there's the other half of the Boost switch, here, too. If the Gain
control is set high, the incoming signal will overdrive this second amplification
stage to create some preamp distortion.
The output of this stage then runs through a network of resistors,
capacitors and pots that allow you to control the treble, middle and bass
frequencies of the signal that will be passed along to the power valve. This is a
'lossy' tone stack, meaning that in order to adjust the TMB frequencies, it must throw away part of the
amplified signal. With the Bypass switch (S2) enabled, however, you can choose to have the full output
of this stage passed along to the power valve.
Power stage
The reddish shaded section shows the power stage, which includes the Master volume control, the
power valve and the output transformer. The Master volume is the simplest part - a pot that lets you dial
in how much signal the power valve receives. Low settings for
cleaner tones, and at higher settings you can overdrive this
valve to get maximum distortion.
The N5X includes a 'noval' socket for EL84 valves (like the
SE-5a), but also has an octal power valve socket, V3. So you can
plug in a 6V6/6L6/EL34/etc instead of the EL84. These bigger
valves have different overdrive characteristics and tones, and
Содержание N5X
Страница 9: ...9 www ampmaker com...
Страница 13: ...13 www ampmaker com...
Страница 33: ...33 www ampmaker com...