Main Active Speaker Wire Connection:
Connect the audio wires connecting active speakers to three passive speakers through conduit. Pre
terminate the wire and connect the Phoenix plug to the wire. Punch the knockout on the side of the
handy box. After the connection is made, make sure to close the handy box with the cover provided.
The audio wires should be a two conductor wire with recommended 18 AWG wire.
Connect the Ethernet signal wires through conduit, terminate with RJ45 connector, punch the one of
the knock out where RJ45 jack is located, than plug it into the speaker. After the connection is made,
make sure to close the handy box with the cover provided.
Three Light Indicators:
When RJ45 connection is made, you should be seeing some lights blinking on
the right side of the RJ45 connection handy box as shown.
From top to bottom, it will be Power, Dante, and Status.
○
Power: This shows the power coming from PoE+ network switch. If there is no power present,
then the light will not turn green. The speaker must be running from PoE+ network switch
in order to get the green light.
○
Dante: This will blink red in the beginning as it is trying to connect with the computer system.
When connection is made and Dante signal is confirmed, the light will turn green.
○
Status: As the audio signal gets transmitted into the speaker system, the light will blink green as
the signals go through.
The connection should be
made Cat5 or above cable for
the Ethernet connection.
