Amity Technology 3200, Руководство по эксплуатации

Страница: 39 / 77

7 - 12
7.6.2 Bar height
The Amity scalper bar has two standard mounting positions as shown in the figures below. The bar
height should be set to ensure the scalper baskets cannot reach the maximum or minimum stops
and instead operate smoothly in the range between them. The scalper bar is set in the central posi-
tion from factory. Adjust the bar height so it is correct for your conditions according to the diagrams
below. Although not typically used the inner cylinder hole may be used to lower the scalper bar fur-
ther if needed. When the lowest setting is used or the defoliator is not being operated level front to
back, the slotted hole on the bar weldment shown below is required to level the scalper bar.
Figure 7 - 15: Highest Scalper Position
Figure 7 - 16: Lower Scalper Position