RRU-WTB/AN01
23/28
rru-wtban01_g_en_100
9. Mounting, installation rules
9.1. Mounting instructions
Analyser
RRU-WTB/AN01
is intended to be mounted into 19“ subrack. After the
analyser is put in to rack it must be fixed with four screws in plastic sleeves in
four corners of front panel.
127
12
2
4x A
A:
Fig. 10 -
Mounting into 19“ subrack
If needed, analyser can be mounted in a suitable frame. In case of mounting
into the frame, four screws with M3 thread are used (not included). In this case
it is necessary to remove four plastic grommets together with four screws M2.5
from the front panel. The tube can be mounted into frame arbitrary. The tube
must be always fastened so that the whole weight of analyser does not load
only the four mounting screws mentioned above.
