Amit AIPM1010/A, Руководство по эксплуатации

Страница: 15 / 52

KS-111E
15/52 ks-111e_g_en_100
Before start of camera installation is necessary to set camera system into fol-
lowing state:

Powering of all components is switched off

All cameras are disconnected from Ethernet

Service PC with installed ACM is connected

The database in ACM does not involve cameras connected before (oth-
erwise they must be deleted
– see chapter 4.2.4 Camera lens setup (po-
sitioning and focusing), section Deleting camera from ACM database).
Setting of service notebook network adapter:
IP Address: 172.16.5.33
Subnetwork mask: 255.255.255.0
Outgoing gateway: do not fill
4.2.1 Camera identification
The first step is identification of particular camera. There are two scenarios
available, which can be used for identification:
Cables are labelled near PoE switch
– therefore cameras can be identified by
connection.
Attaching camera to Ethernet
Plug the Ethernet cable into the appropriate connector of particular camera and
wait for cca 30 s (time for camera startup).
Finding of attached camera through ACM
Launch the ACM on service PC and click on Search icon on Toolbar .
Fig. 8 - ACM
– the Search icon
In next dialog enter the value of
„
IP range
“ for searching (APPENDIX E – Con-
figuration parameters, IP address setting up) and confirm by OK button.