Amish Country Gazebos Wood Gazebo-in-a-Box, Руководство по сборке

Страница: 14 / 28

9
Step 9. Install the plywood roof panels
1. Begin with the largest plywood panel first.
Note: Align the bottom
edge of the plywood with
the outside edge of your
fascia board.
Hint: Start a 2" screw
in each corner along the
bottom and 3" from bottom
edge and ½" from side.
Note: Only one screw is
required per section to connect
the plywood to the fascia board.
2.
Attach each bottom corner of the
plywood to a rafter with 2” screws
(1 screw into the left rafter and
1 screw into the right rafter).
3. Next, go to the center of the
plywood panel where it meets the
fascia board. Pull the fascia board out
slightly to properly align it, then drive
one 2” screw through the plywood
and into the fascia board.
5. Fasten each of these large plywood
panels to the rafters with 2” screws
spaced at 12”-16” on center.
10
Now your plywood roof panels can be attached to the roof rafters using the 2” screws.
Be sure to place the best side of the plywood down since this will be the ceiling of your gazebo.
4. Continue by installing each of the
eight large plywood panels around
the lower roof perimeter.
6. Then climb up onto the roof and
fasten the remaining plywood panels
into place.