HD SkyLink
Manual AMIMON HD SkyLink
page
|
13
www.globe-flight.de
Frequency settings
The HD SkyLink system is flexible and easy to adjust to all different fields of use and to meet the regional
and national frequency requirements and laws.
The 5 GHz frequency band is split up into 3 different types which can be used with the HD SkyLink system,
the ISM frequencies, DSF frequencies and NON-DFS frequencies. Please view the following table to see the
different frequencies and types of usage.
Please always check the used frequency for your application and country or region. To use DFS frequencies
for remote controlled vehicles in the air, a special frequency registration at the Federal Network Agency is
required. You can find further information about the necessary steps to be taken via the following link.
Federal Network Agency
Frequency table for Europe
Frequencies in MHz
Description
Usage
5190
NON-DFS
Indoor max. 200mW EIRP
5230
NON-DFS
5270
DFS (short cac)
Indoor and outdoor
Max. 200mW EIRP
(For aerial usage, a special registration is
required)
5310
DFS (short cac)
5510
DFS (short cac)
5550
DFS (short cac)
5590
DFS (long cac)
5630
DFS (long cac)
5670
DFS (short cac)
5755
ISM; NON-DFS
Indoor, outdoor and in the air
Max. 25mW EIRP
5795
ISM; NON-DFS
5835
ISM; NON-DFS
The HD SkyLink comes with activated DFS frequencies, which make the general use indoors and outdoors
possible by default. To change the frequency settings, please follow the steps below.
1. Install the WHDI Monitor software (WHDI Monitor.exe) on your computer. Double click the file WHDI
Monitor.exe and go through the necessary steps.
2. Power up your HD SkyLink device (frequency changes have to be done both for the transmitter and the
receiver separately in the same way)
3. Connect your HD SkyLink Kite transmitter (and later the Falcon receiver) to your computer using the USB
port. Your computer will install the necessary USB drivers automatically, if the driver is not found please
install it manually from the .zip file you have downloaded.
4. Open the installed WHDI Monitor software and wait until your device is connected.
