Amigo EXT350, Руководство по эксплуатации для владельца

Страница: 7 / 28

Models with TouchTron controls have an additional Electromagnetic Brake Release
Button located on the Handle (Figure 6). To electronically release the Electromagnetic
Brake, push the Brake Release Button twice. The low-speed segment of the Speed
Gauge will blink to indicate you are now in the “Freewheeling” mode. To terminate the
“Freewheeling” mode when selected electronically, activate any control button
(except Horn Button) on the TouchTron Handle.
Brake Releases for Manual Pushing
Note: Do not leave Manual Brake Release on, as it will drain batteries.
Electromagnetic Brake Release
(located on Handle)
– Figure 6
Manual Brake Lever
(located on Rear Cover)
– Figure 5
Sleep Mode
A Battery Indicator and Diagnostic System are incorporated into the Touchpad of all
Amigo
® Rear Drive models with a TouchTron Handle. The Battery Status Gauge will be lit
whenever the Key is in the ON position. However, if the Amigo is inactive for more than
25 minutes, the Amigo automatically switches to “Sleep Mode.” This feature substantially
reduces power to conserve battery capacity. To reactivate your Amigo, switch it OFF
and then ON again to regain full function. It is strongly recommended that you turn the
Key to the OFF position each time you are through using the Amigo to insure the power
is completely turned off.
Power Seat Lift Operation • Optional
To operate the Power Seat Lift on Amigo models with a TouchTron Handle,
press the Seat/Directional Arrow Buttons to raise or lower the Seat (Figure 7).
To lift the seat to desired height, press the Seat Button with the arrow pointing
up. To lower the seat, press the Seat Button with the arrow pointing down.
The Power Seat Lift can be activated only when you are not moving.
Always drive with the Power Seat Lift in its lowest position.
TO AVOID DAMAGING THE MOTOR OF THE POWER SEAT LIFT,
RELEASE THE SEAT BUTTON AFTER THE SEAT HAS REACHED ITS
HIGHEST OR LOWEST POINT.
High Intensity Light Package Operation • Optional
The optional lighting package available with the TouchTron Handle includes a Front Headlight, Rear Taillight
and Turn Signals. The power must be ON to operate the Headlight or Taillight. The Headlight and Taillight can
be activated by pressing the Headlight Button (Figure 6). Press this Button again to turn the Lights off.
The Turn Signals can be activated by pressing the left or right Turn Signal Buttons. (Figure 7). Indicate a
“hazard” condition by pressing both Turn Signals. The power must be ON to operate the lights.
RIDING YOUR AMIGO
For your first sessions, be sure you are on a level surface. Insert the key in the switch, but leave it turned OFF. Stand behind
the seat and reach down to the Seat Lock Lever. It is located on the right side directly under the seat (can be configured on
either side of the seat; standard position is on the right side). Grasp the end of the Lever and push forward, releasing the
seat. It will now turn easily to meet you. When seat is positioned for transfer, engage Lever to the Locked position to steady
the seat before you sit down. When seated, release the Seat Lock and turn forward to driving position. When positioned,
re-engage Lever to the Locked position, if desired. Then, turn the Speed Adjustment Knob counterclockwise, and turn the
key to the ON position. Pull the Right Accelerator Lever to start off in a Forward motion. To stop, simply let go;
this will apply your brake.
7
Figure 7
Up
Down
Figure 6
Headlight/
Taillight
Electronic
Brake
Switch
Turn Signal Turn Signal