Amigo EXT350, Руководство по эксплуатации для владельца

Страница: 13 / 28

If you remove your batteries from your Amigo, put them on a surface that cannot be damaged by acid fumes. Whenever a
battery is charged and discharged through a cycle, it breathes. The breathing of the battery emits acid fumes into the cloth
strap (used to lift the batteries on Rear Drive models) and may mark surfaces it rests on for long periods of time.
Store batteries indoors in a dry environment, away from any open flames. Temperature range is 0˚C (32˚F) to 40˚C (104˚F).
CLEANING INSTRUCTIONS
Tires
The Tires should be cleaned with ordinary kitchen-type cleaners and a damp cloth.
Don’t use solvents on Tires as they cause tire material to break down or become too soft.
Cover
The Cover of the Amigo is constructed of ABS plastic and coated with a durable automotive type finish. Therefore, the Cover
can be cleaned like a car. Use cool water with mild soap to remove dirt and oils. Do not spray the entire vehicle with water.
This will damage the electrical parts. The Cover may be waxed with car body wax and buffed by hand with a soft cloth.
Seat
The Vinyl Seat can be cleaned with a mild soap or detergent and a damp cloth. A vinyl cleaner can also be used.
Cloth Seats can be cleaned with a damp cloth or as any upholstery. Care should be taken not to soak Cloth Seats,
as the interior foam rubber will hold water.
Floor Mat
The floor mat should be cleaned with ordinary kitchen-type cleaners and a damp cloth.
Do not use solvents on the floor mat, as they may cause the floor mat material to break down.
KEEP CLEANING SOLVENTS AWAY FROM ELECTRICAL WIRES AND CONNECTIONS.
MAINTENANCE
Minimum maintenance should prevent unnecessary repairs. You will get years of dependable operation
if you follow the suggested maintenance schedule. Check the following:
Daily
Charge batteries daily when the Amigo is used. Charge the battery until fully charged to ensure
proper battery operation. Extended charging is good for the batteries and will not overcharge them.
Monthly
Check and clean Battery Terminals and the Wire Connections as needed with
a light piece of emery cloth or brush and soda water.
• Clean upholstery, plastic and metal with a mild surface cleaner.
• Inspect batteries for any cracks or damage of any kind.
• Check and tighten any exposed Fasteners.
• Make sure all Fasteners are tight on all Battery Connections.
• Check tire pressure on Pneumatic Tires. When air filling tires, always refer to the Manufacturer’s Specifications
located on the face of the tire. Uneven tire pressure will cause the overheating of the Controller that will
lead to failure of the vehicle.
13