①
Switch on the WIFI of the portable power device
②
Plug in the cable from ADSL
③
Turn on the WIFI of the cellphone and connect to wifi_xxxxxx (6 random numbers )
④
Open the cellphone's browser; input 192 168 10 1 and click OK to enter the navigation of WIFI setting (When the first time you login please use
6.IP dial-up:
④
Open the cellphone s browser; input 192.168.10.1 and click OK to enter the navigation of WIFI setting (When the first time you login, please use
admin as the username and password)
⑤
In the WIFI navigation page, click the Internet type setting; select PPPoE (ADSL) as the Wide area network online mode; input your
user and password, confirm your password, and click OK
√
Setting is completed, this device will restart WIFI and reconnect
5
①
Switch on the WIFI of the portable power device
②
Turn on the WIFI of the cellphone and connect to wifi_xxxxxx (6 random numbers )
③
Open the cellphone's browser; input 192.168.10.1 and click OK to enter the navigation of WIFI setting (When the first time you login, please use
admin as the username and password)
④
In the WIFI navigation page, click the Advanced Setting; click opperating pattern; click Gateway, click OK
√
Setting is completed, this device will restart WIFI and reconnect
7.Turn off the Bridging mode:
g
p
,
FCC WARNING
4
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the
supplied antenna.
4
