15
OPERATION
Control Panel
● Immediately after the appliance is connected to electrical mains, all displays will light up
briefly. Your induction hob is then ready for use.
● The induction hob is equipped with electronic touch control sensor fields, which are
operated by touching with a finger for at least 1 second.
● Touching of a sensor field is accompanied by an acoustic signal to acknowledge.
No objects should be placed on the sensor fields (this could cause an error).
Touch sensor fields should be always kept clean.
Selecting the cooking zone heat setting
While the number "0" is flashing on the cooking zone display, you can start adjusting the heat
setting sliding your finger across the slider sensor (1). The default heat setting is "0".
Switching on the cooking zones
Once the appliance is switched on using the on/off touch sensor (
5
), select a cooking zone
(
2
) within the next 60 seconds.
1 When a cooking zone selection sensor field (
2
) is touched, a flashing "0" will be displayed
on the corresponding heat setting indicator display. The display will flash for about 5 sec
-
onds. Set a heat setting during this time.
Switching on the appliance
To switch on the appliance touch and hold the on/off sensor field (
5
) for at least 1 second.
The appliance will sound an acoustic signal when it is ready for use. When the appliance
is ready for use, is shown on the timer display and
symbols are shown on cooking
zone displays.
If none of the sensor fields is touched within 60 seconds, the appliance switches
itself off.
A cooking zone is active when a number is flashing on its display. This indicates
a cooking zone is ready for the heat setting to be set or changed.
Heat setting selection sensor (1) is a slider type touch control sensor allowing selec
-
tion of heat setting (1-9) and timer setting (1-99) by touching and sliding your finger
across the marked area (1):
sliding right - increase the heat setting
sliding left - reduce the heat setting.
It is also possible to select the heat setting directly by touching the appropriate part of
the heat setting selection sensor field (1).
1
2
3
5
6
7
8
4
2
