20
NOTE:
You find information about the amount of detergent for the single programme on the last
page.
Please be aware that according to the level soiling and the specific hardness of water,
differences are possible.Please observe the manufacturer’s recommendations on the
detergent packaging.
Detergents
There are 3 sorts of detergents
1.With phosphate and with chlorine
2.With phosphate and without chlorine
3.Without phosphate and without chloride
Normally new pulverized detergent is without phosphate. The water softener function of
phosphate is not given. In this case we recommend to fill salt in the salt container even
when the hardness of water is only 6 dH. If detergents without phosphate were used in
case of hard water often white spots appear at dishes and glasses. In this case please
add more detergent to reach better results. Detergents without chlorine do only bleach a
little. Strong and coloured spots will not removed completely. In this case please choose a
programme with higher temperature.
Use of „3 in 1” Detergent Tablets
General Advice
1. Before using these products you should first check that the water hard-ness in your
supply is compatible with the use of these products as per the detergent manufacturers
instructions (on the product packaging).
2. These products should be strictly used according to the detergent manufacturers instruc-
tions.
3. If you encounter problems when using „3 in 1” products for the first time then please con
-
tact the detergent manufacturers care line (the telephone number is given on the product
packaging).
These products are detergents with integrated and combined detergent/rinse aid and salt
functions.
Before using these products you should first check that the water hardness in your supply
is compatible with the use of these products as per the detergent manufacturers (on the
product packaging).
Special Advice
When using combination products, the rinse-aid and salt lights are no longer useful. It may
be helpful to select the lowest possible setting for water hardness.
To select „3in1” function:
1. Press the power switch and select the 3in1 washing cycle by pressing the button „ ALT”
until the „3in1” indicator blinks.
2. The 3in1 washing cycle will be available after pressing the start/pause button , and
the”3in1” indicator lights.
To cancel “3in1” function:
1. Follow the ‘Cancelling a programme in progress’ instructions.If you decide to switch to
the use of a standard detergent system we advise that you:1. Refill both the salt and rinse
aid compartments.
2. Switch the water hardness setting to the highest possible position and run for three
normal cycles without load.
3. Readjust the water hardness setting again according to the conditions for your region
(For more information please refer to your instruction manual).
Note:3in1 washing cycle is additional function, they must be used with other programme
(Intensive, Eco and Light).
