26
Cleaning the Spray Arms
It is necessary to clean the spray arms regularly for hard water chemicals will clog
the spray arm jets and bearings. To remove the spray arms, screw off the nut cloc
-
kwise to take out the washer on top of the spray arm and remove the arm. Wash the
arms in soapy and warm water and use a soft brush to clean the jets. Replace them
after rinsing thoroughly.
2
Caring for the Dishwasher
To clean the control panel, use a lightly dampened cloth then dry thoroughly. To cle-
an the exterior, use a good appliance polish wax. Never use sharp objects, scouring
pads or harsh cleaners on any part of the dishwasher.
3
Protect Against Freezing
If your dishwasher is left in an unheated place during the winter, ask a service
technical to:
1.Cut off electrical power to the dishwasher.
2.Turn off the water supply and disconnect the water inlet pipe from the water
valve.
3.Drain water from the inlet pipe and water valve. (Use a pan to catch the water)
4.Reconnect the water inlet pipe to the water valve.
5.Remove the filter in the tub and the bottom and use a sponge to use up water in
sump.
4
Cleaning the Door
To clean the edge around the door, you should use only a soft warm, damp rag. To
prevent penetration of water into the door lock and electrical components, do not
use a spray cleaner of any kind. Also, never use abrasive cleaners or scouring pads
on the outer surfaces because they will scratch the finish. Some papers towels can
also scratch or leave marks on the surface.
5
Never use a spray cleaner to clean the door panel for it could damage the door lock and
electrical components. It is not allowed to use the abrasive agent or some paper towel
because of the risk of scratching or leaving spots on the stainless steel surface.
