10
| Instruction Manual
Mounting your extractor
When the extractor is to be installed
above an Amica hob, the minimum
distance between the hob and the
extractor must exceed 550mm.
If the instructions provided with
another brand of gas hob state that
the required distance between the
hob and the extractor must be greater
than 550mm, then that is the distance
that should be observed; this is a
legal requirement and may lead to
your hob being disconnected from
the gas supply and the installation
being reported under RIDDOR.
Note:
The height should be
measured from the top of the burners.
AEC60SS / AEC90SS
A
53mm
B
151mm
C
Height dependent
D
105mm
E
75mm
F
73mm
Gas: 750mm recommended
Electric: 650mm recommended
C
E
F
D
Centre
B
A
Fig. 4
IN THE ABSENCE OF ANY INSTRUCTIONS SUPPLIED WITH
THE GAS HOB, THE MINIMUM DISTANCE BETWEEN THE HOB
AND THE EXTRACTOR MUST BE AT LEAST 760mm.
The width of any hob must not be greater than the width of the
extractor installed above it.
Ducting and ventilation
For best performance and lowest noise output we recommend the
use of 150mm ducting. 125mm ducting may be used but this will
reduce performance and increase the noise of the extractor.